CONTENTS

SYNOPSIS

To compile in debugging code:


.Cd options AHD_DEBUG


.Cd options AHD_DEBUG_OPTS=<bitmask of options>


.Cd options AHD_REG_PRETTY_PRINT

To configure one or more controllers to assume the target role:


.Cd options AHD_TMODE_ENABLE=<bitmask of units>

Driver features include support for narrow and wide busses, fast, ultra, ultra2, ultra160, and ultra320 synchronous transfers, packetized transfers, tagged queueing, 512 SCB’s, and target mode.

The AHD_DEBUG_OPTS option is used to control which diagnostic messages are printed to the console when AHD_DEBUG is enabled. Logically OR the following bits together: "Value Function" 0x0001 Show miscellaneous information 0x0002 Show sense data 0x0004 Show Serial EEPROM contents 0x0008 Show bus termination settings 0x0010 Show host memory usage 0x0020 Show SCSI protocol messages 0x0040 Show mode pointer of the chip register window 0x0080 Show selection timeouts 0x0100 Show FIFO usage messages 0x0200 Show Queue Full status 0x0400 Show SCB queue status 0x0800 Show inbound packet information 0x1000 Show S/G list information 0x2000 Enable extra diagnostic code in the firmware

The AHD_REG_PRETTY_PRINT option compiles in support for human-readable bit definitions for each register that is printed by the debugging code. However, it also bloats the compiled size of the driver by approximately 215KB.

Individual controllers may be configured to operate in the target role through the AHD_TMODE_ENABLE configuration option. The value assigned to this option should be a bitmap of all units where target mode is desired. For example, a value of 0x25 would enable target mode on units 0, 2, and 5. Note that target mode is only supported for ultra160 speeds and below.

• Adaptec AIC7901 host adapter chip
• Adaptec AIC7901A host adapter chip
• Adaptec AIC7902 host adapter chip
• Adaptec 29320 host adapter
• Adaptec 39320 host adapter
• Many motherboards with on-board SCSI support

SEE ALSO

HISTORY

AUTHORS

BUGS