:man| Alphabetical   Categories   About us 
GETITIMER (2) | System calls | Unix Manual Pages | :man


getitimer, setitimer - get/set value of interval timer


Return Values
See Also


.Lb libc


.In sys/time.h
.Fd "#define ITIMER_REAL 0"
.Fd "#define ITIMER_VIRTUAL1"
.Fd "#define ITIMER_PROF 2" int getitimer "int which" "struct itimerval *value" int setitimer "int which" "const struct itimerval *value" "struct itimerval *ovalue"


The system provides each process with three interval timers, defined in
.In sys/time.h . The getitimer system call returns the current value for the timer specified in which in the structure at value. The setitimer system call sets a timer to the specified value (returning the previous value of the timer if ovalue is not a null pointer).

A timer value is defined by the itimerval structure:
struct itimerval {
struct timeval it_interval; /* timer interval */
struct timeval it_value; /* current value */

If it_value is non-zero, it indicates the time to the next timer expiration. If it_interval is non-zero, it specifies a value to be used in reloading it_value when the timer expires. Setting it_value to 0 disables a timer, regardless of the value of it_interval. Setting it_interval to 0 causes a timer to be disabled after its next expiration (assuming it_value is non-zero).

Time values smaller than the resolution of the system clock are rounded up to this resolution (typically 10 milliseconds).

The ITIMER_REAL timer decrements in real time. A SIGALRM signal is delivered when this timer expires.

The ITIMER_VIRTUAL timer decrements in process virtual time. It runs only when the process is executing. A SIGVTALRM signal is delivered when it expires.

The ITIMER_PROF timer decrements both in process virtual time and when the system is running on behalf of the process. It is designed to be used by interpreters in statistically profiling the execution of interpreted programs. Each time the ITIMER_PROF timer expires, the SIGPROF signal is delivered. Because this signal may interrupt in-progress system calls, programs using this timer must be prepared to restart interrupted system calls.

The maximum number of seconds allowed for it_interval and it_value in setitimer is 100000000.


Three macros for manipulating time values are defined in
.In sys/time.h . The timerclear macro sets a time value to zero, timerisset tests if a time value is non-zero, and timercmp compares two time values.


.Rv -std


The getitimer and setitimer system calls will fail if:
The value argument specified a bad address.
The value argument specified a time that was too large to be handled.


gettimeofday(2), select(2), sigvec(2), clocks(7)


Created by Blin Media, 2008-2013