:man| Alphabetical   Categories   About us 
 
CUE (4) | Special files and drivers | Unix Manual Pages | :man

NAME

cue - "CATC USB-EL1210A USB Ethernet driver"

CONTENTS

Synopsis
Description
Hardware
Diagnostics
See Also
History
Authors

SYNOPSIS

To compile support for the cue driver into your kernel, place the following lines in your kernel configuration file:


.Cd "device uhci"


.Cd "device ohci"


.Cd "device usb"


.Cd "device cue"

Alternatively, to load the cue(4) driver at boot time, place the following line in loader.conf(5):
if_cue_load="YES"

DESCRIPTION

The cue driver provides support for USB Ethernet adapters based on the Computer Access Technology Corporation’s USB-EL1210A chipset.

The USB-EL1210A supports a 512-bit multicast hash filter, single perfect filter entry for the station address and promiscuous mode. Packets are received and transmitted over separate USB bulk transfer endpoints.

The CATC chipset supports only 10Mbps half-duplex mode, hence there are no ifmedia(4) modes to select.

For more information on configuring this device, see ifconfig(8).

HARDWARE

The cue driver supports CATC USB-EL1210A based USB Ethernet adapters including:

  • Belkin F5U011/F5U111
  • CATC Netmate
  • CATC Netmate II
  • SmartBridges SmartLink

DIAGNOSTICS

"cue%d: watchdog timeout" A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired.
"cue%d: no memory for rx list" The driver failed to allocate an mbuf for the receiver ring.

SEE ALSO

arp(4), netintro(4), ng_ether(4), ifconfig(8)

HISTORY

AUTHORS


Share this page

     Follow us

Facebook Twitter Google+ LinkedIn


 
Created by Blin Media, 2008-2013